H3C S3600 Series User Manual

Operation Manual – System Maintenance and Debugging
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 4
Device Management
4-1
Chapter 4 Device Management
4.1 Introduction to Device Management
The device management function of the Ethernet switch enables the display of current
status and event-debugging information of the system. Through this function, you can
maintain and manage the status and communication of the physical devices, and
restart the system when some functions of the system are exceptional.
4.2 Device Management Configuration
4.2.1 Device Management Configuration Tasks
Table 4-1 Device management configuration tasks
Operation Description Related section
Reboot the Ethernet
switch
—
Section 4.2.2 “Rebooting the
Ethernet Switch
”
Schedule a reboot on the
switch
Optional
Section 4.2.3 “Scheduling a Reboot
on the Switch
”
Specify the ARP to be
adopted at reboot
Optional
Section
4.2.4 “Specifying the APP
to be Adopted at Reboot
”
Update the BootROM Optional
Section
4.2.5 “Upgrading the
BootROM
”
Update the host software
in the Fabric
Optional
Section 4.2.6 “Upgrading the Host
Software in the Fabric
”
4.2.2 Rebooting the Ethernet Switch
You can perform the following operation in user view when the switch is faulty or needs
to be rebooted.
 Note:
Before rebooting, the system checks whether there is any configuration change. If yes,
it prompts whether or not to proceed. This prevents the system from losing the
configurations in case of shutting down the system without saving the configurations

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English