H3C S3600 Series User Manual

Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-20
Caution:
z In string mode, if the VLAN ID assigned by the RADIUS server is a character string
containing only digits (for example, 1024), the switch first regards it as an integer
VLAN ID: the switch transforms the string to an integer value and judges if the value
is in the valid VLAN ID range; if it is, the switch adds the authenticated port to the
VLAN with the integer value as the VLAN ID (VLAN 1024, for example).
z To implement dynamic VLAN assignment on a port where both MSTP and 802.1x
are enabled, you must set the MSTP port to an edge port.
1.3.6 Configuring the Attributes of a Local User
When local scheme is chosen as the AAA scheme, you should create local users on
the switch and configure the relevant attributes.
The local users are users set on the switch, with each user uniquely identified by a user
name. To make a user who is requesting network service pass local authentication, you
should add an entry in the local user database on the switch for the user.
Table 1-10 Configure the attributes of a local user
Operation Command Description
Enter system view
system-view
—
Set the password display
mode of all local users
local-user
password-display-mode
{ cipher-force | auto }
Optional
By default, the password
display mode of all access
users is auto, indicating
the passwords of access
users are displayed in the
modes set by the
password command.
Add a local user and enter
local user view
local-user user-name
Required
By default, there is no
local user in the system.
Set a password for the
local user
password { simple |
cipher } password
Optional
Set the status of the local
user
state { active | block }
Optional
By default, the user is in
active state, that is, the
user is allowed to request
network services.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English