H3C S3600 Series

Operation Manual – Port Basic Configuration
H3C S3600 Series Ethernet Switches-Release 1510 Table of Contents
i
Table of Contents
Chapter 1 Port Basic Configuration ............................................................................................ 1-1
1.1 Ethernet Port Overview...................................................................................................... 1-1
1.1.1 Types and Numbers of Ethernet Ports.................................................................... 1-1
1.1.2 Link Types of Ethernet Ports................................................................................... 1-2
1.1.3 Configuring the Default VLAN ID for an Ethernet Port............................................ 1-2
1.1.4 Adding an Ethernet Port to Specified VLANs.......................................................... 1-3
1.2 Ethernet Port Configuration ............................................................................................... 1-4
1.2.1 Initially Configuring a Port ....................................................................................... 1-4
1.2.2 Limiting Traffic on individual Ports .......................................................................... 1-5
1.2.3 Enabling Flow Control on a Port ............................................................................. 1-5
1.2.4 Configuring Access Port Attribute ........................................................................... 1-6
1.2.5 Configuring Hybrid Port Attribute ............................................................................ 1-6
1.2.6 Configuring Trunk Port Attribute.............................................................................. 1-7
1.2.7 Copying the Configuration of a Port to Other Ports ................................................ 1-7
1.2.8 Configuring Loopback Detection for an Ethernet Port ............................................ 1-8
1.2.9 Configuring the Ethernet Port to Run Loopback Test........................................... 1-10
1.2.10 Enabling the System to Test Connected Cable.................................................. 1-11
1.2.11 Configuring the Interval to Perform Statistical Analysis on Port Traffic .............. 1-11
1.2.12 Enabling Giant-Frame Statistics Function........................................................... 1-11
1.2.13 Displaying Basic Port Configuration.................................................................... 1-12
1.3 Ethernet Port Configuration Example.............................................................................. 1-13
1.4 Troubleshooting Ethernet Port Configuration .................................................................. 1-14