Operation Manual – SNMP-RMON
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
SNMP Configuration
1-8
1.4 Enabling Logging for Network Management
Table 1-5 Enable logging for network management
Operation Command Description
Enter system view
system-view
—
Enable logging for
network management
snmp-agent log
{ set-operation |
get-operation | all }
Optional;
By default, SNMP logging
is disabled.
Note:
z In the environment of a single device, use the display logbuffer command to view
the log of the get and set operations requested by the NMS.
z In a fabric environment, use the display logbuffer command on the master device
to view the log of the set operations requested by the NMS. Use the display
logbuffer command on the devices receiving the get request to view the log of the
get operations requested by the NMS.
1.5 Displaying SNMP
After the above configuration, you can execute the display command in any view to
view the running status of SNMP, and to verify the configuration.
To Next Page
Loading...
Need help?
General