Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 4 Multicast MAC Address Entry
Configuration
4-2
Note:
z If the multicast MAC address entry to be created already exists, the system gives
you a prompt.
z If you want to add a port to a multicast MAC address entry created through the
mac-address multicast command, you need to remove the entry first, create this
entry again, and then add the specified port to the forwarding ports of this entry.
z The system does not support adding multicast MAC addresses to IRF ports. If a port
is already an IRF port, the system will prompt that you cannot add multicast MAC
addresses to this port.
z You cannot enable link aggregation on a port on which you have configured a
multicast MAC address; and you cannot configure a multicast MAC address on an
aggregation port.
4.3 Displaying and Maintaining Multicast MAC Address
After the configuration above, you can execute the display command in any view to
verify the configuration effect by checking the displayed information.
Table 4-3 Display and maintain multicast MAC address
Operation Command Description
Display the multicast
MAC address
entry/entries manually
configured
display mac-address
multicast [ static
{ { { mac-address vlan
vlan-id | vlan vlan-id }
[ count ] } | count } ]
You can use the display
command in any view.
To Next Page
Loading...
Need help?
General