H3C S3600 Series

Operation Manual – Login
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 7 Configuring Source IP Address for Telnet
Service Packets
7-2
 Note:
z To perform the configurations listed in Table 7-1 and Table 7-2, make sure that:
z The IP address specified is that of the local device.
z The interface specified exists.
7.2 Displaying Source IP Address Configuration
Execute the display command in any view to display the operation state after the
above configurations. You can verify the configuration effect through the displayed
information.
Table 7-3 Display the source IP address configuration
Operation Command
Display the source IP address
configured for the Telnet client
display telnet source-ip
Display the source IP address
configured for the Telnet server
display telnet-server source-ip