Operation Manual – AAA-RADIUS-HWTACACS-EAD
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 AAA & RADIUS & HWTACACS
Configuration
1-47
z The communication links (physical/link layer) between the switch and the RADIUS
server is disconnected/blocked — Take measures to make the links
connected/unblocked.
z None or incorrect RADIUS server IP address is set on the switch — Be sure to set
a correct RADIUS server IP address.
z One or all AAA UDP port settings are incorrect — Be sure to set the same UDP
port numbers as those on the RADIUS server.
Symptom 3: The user passes the authentication and gets authorized, but the
accounting information cannot be transmitted to the RADIUS server.
Possible reasons and solutions:
z The accounting port number is not properly set — Be sure to set a correct port
number for RADIUS accounting.
z The switch requests that both the authentication/authorization server and the
accounting server use the same device (with the same IP address), but in fact they
are not resident on the same device — Be sure to configure the RADIUS servers
on the switch according to the actual situation.
1.8.2 Troubleshooting HWTACACS Configuration
See the previous section if you encounter an HWTACACS fault.
To Next Page
Loading...
Need help?
General