H3C S3600 Series User Manual

Operation Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 7 PIM Configuration
7-17
Operation Command Description
Configure PIM-SM
domain boundary
pim bsr-boundary
Required
By default, domain
boundary is not set for the
switch.
Caution:
z After the PIM-SM domain boundary is set, Bootstrap messages cannot pass the
boundary in any direction. In this way, PIM-SM domains are divided.
z After this feature is configured, Bootstrap messages cannot pass the boundary.
However, the other PIM messages can pass the domain boundary. The network can
be effectively divided into domains that use different BSRs.
7.4.4 Filtering the Registration Packets from RP to DR
Through the registration packet filtering mechanism in a PIM-SM network, you can
determine which sources send packets to which groups on RP, that is, RP can filter the
registration packets sent from DR and receive the specified packets only.
Table 7-10 Filter the registration packets from RP to DR
Operation Command Description
Enter system view system-view —
Enable the multicast
routing protocol
multicast
routing-enable
Required
Enable the multicast
routing protocol
Enter VLAN interface
view
interface Vlan-interface
interface-number
—
Enable PIM-SM on the
current interface
pim sm
Required
Configure the PIM
protocol type on the
interface
Quit VLAN view
quit
—
Enter PIM view
pim
—

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English