H3C S3600 Series

Operation Manual – Cluster
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Cluste
r
1-12
1.2.9 Configuring NM Interface for the Cluster
I. Configuration prerequisites
z The cluster switches are properly connected;
z The shared servers are properly connected to the management switch.
II. Configuration procedure
Table 1-11 Configure NM interface for the cluster
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
Required
Configure the network
management (NM)
interface for the cluster
nm-interface
Vlan-interface vlan-id
Optional
By default, the management
VLAN interface is used as the
NM interface.
1.3 Cluster Configuration on Member Device
1.3.1 Member Device Cluster Configuration Tasks
Table 1-12 Member device Cluster configuration tasks
Operation Description Related section
Enable NDP globally and on
specific ports
Required
Section
1.3.2 “Enabling NDP
Globally and on Specific
Ports
”
Enable NTDP globally and on
a specific port
Required
Section
1.3.3 “Enabling
NTDP Globally and on a
Specific Port
”
Enable the cluster function Required
Section
1.3.4 “Enabling the
Cluster Function
”
Access shared FTP/TFTP
server from a member device
Optional
Section
1.3.5 “Accessing
Shared FTP/TFTP Server