H3C S3600 Series User Manual

Operation Manual – MSTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
MSTP Configuration
1-36
Operation Command Description
Enable the root protection
function on specified ports
stp interface
interface-list
root-protection
Required
The root protection function
is disabled by default.
Table 1-32 Enable the root protection function in Ethernet port view
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
Interface interface-type
interface-number
—
Enable the root protection
function on the current
port
stp root-protection
Required
The root protection
function is disabled by
default.
II. Configuration example
# Enable the root protection function on Ethernet1/0/1.
1) Perform this configuration in system view.
<H3C> system-view
[H3C] stp interface Ethernet1/0/1 root-protection
2) Perform this configuration in Ethernet port view.
<H3C> system-view
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] stp root-protection
1.5.5 Configuring Loop Prevention
I. Configuration procedure
Table 1-33 Configure loop prevention
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable the loop
prevention function on the
current port
stp loop-protection
Required
The loop prevention
function is disabled by
default.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English