H3C S3600 Series

Operation Manual – MSTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
MSTP Configuration
1-24
[H3C] stp interface Ethernet1/0/1 point-to-point force-true
2) Perform this configuration in Ethernet port view.
<H3C> system-view
[H3C] interface Ethernet1/0/1
[H3C-Ethernet1/0/1] stp point-to-point force-true
1.2.14 Enabling the MSTP Feature
I. Configuration procedure
Table 1-19 Enable the MSTP feature in system view
Operation Command Description
Enter system view
system-view
—
Enable the MSTP feature
stp enable
Required
MSTP is disabled by default.
Disable the MSTP feature
on specified ports
stp interface
interface-list
disable
Optional
By default, the MSTP feature is
enabled on all ports after you
enable the MSTP feature in
system view.
To enable a switch to operate
more flexibly, you can disable
MSTP on specific ports. As
MSTP-disabled ports do not
participate in spanning tree
calculation, this operation saves
CPU resources of the switch.
Table 1-20 Enable the MSTP feature in Ethernet port view
Operation Command Description
Enter system view
system-view
—
Enable the MSTP feature
stp enable
Required
MSTP is disabled by
default.
Enter Ethernet port view
interface interface-type
interface-number
—