Operation Manual – Product Overview
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 2
Product Overview
2-3
Part Features
5 IP Address and
Performance
Configuration
z Configuring an IP address for a switch
z Configuring the TCP attributes for a switch
6 Management
VLAN
z Management VLAN configuration
z Management VLAN interface configuration
7 Voice VLAN
z Voice VLAN
8 GVRP z GARP VLAN registration protocol (GVRP)
9 Port Basic
Configuration
z Three port states supported: Access, Trunk, and Hybrid
z Setting broadcast storm suppression globally
z Loopback detection supported
z Cable test
10 Link
Aggregation
z Link aggregation control protocol (LACP)
11 Port Isolation
z Port isolation group
12 Port
Security-Port
Binding
z Multiple security modes
z MAC address-to-port binding
13 DLDP z Device link detection protocol (DLDP)
14 MAC Address
Table
z Manually configuring dynamic, static, and black hole MAC
addresses
z Configuring the aging time for MAC addresses
z MAC address learning limit
15 Auto Detect
z Auto detect
z Auto detect applications in static routing, VRRP, and VLAN
interface backup
16 MSTP
z STP/RSTP/MSTP
z VLAN-VPN TUNNEL
z H3C-proprietary MSTP path cost standard
17 Routing
Protocols.
z Static route
z Routing information protocol (RIP) v1/v2
z Open shortest path first (OSPF) (S3600-EI series switches
only)
z Routing policy
18 Multicast
z Internet group management protocol snooping (IGMP
Snooping)
z Internet group management protocol (IGMP) (S3600-EI
series switches only)
z Protocol-independent multicast-dense mode (PIM-DM)
(S3600-EI series switches only)
z Protocol-independent multicast-sparse mode (PIM-SM)
(S3600-EI series switches only)
19 802.1x
z 802.1X authentication
z Guest VLAN
z Huawei authentication bypass protocol (HABP)