H3C S3600 Series

Operation Manual – Auto Detect
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
Auto Detect Configuration
1-3
# Specify to detect the IP address of 192.168.2.2, setting the detecting number to 2.
[H3C-detect-group-10] detect-list 2 ip address 192.168.2.2
# Specify to return reachable as the detecting result if one of the two IP addresses is
reachable.
[H3C-detect-group-10] option or
# Set the detecting interval to 60 seconds.
[H3C-detect-group-10] timer loop 60
# Set the maximum number of retries during a detecting operation to 3.
[H3C-detect-group-10] retry 3
# The IP addresses in the detecting group are detected after 3 seconds the last
detecting operation is performed.
[H3C-detect-group-10] timer wait 3
[H3C-detect-group-10] quit
[H3C]