To Next Page

To Previous Page

Operation Manual – SSH Terminal Service

H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1

SSH Terminal Service

1-26

# Set the SSH authentication method to password. The SSH authentication timeout

period, number of SSH authentication attempts and server key pair update interval can

be the default values.

[H3C] ssh user client001 authentication-type password

 Note:

If you set the SSH authentication method to RSA, you need to configure a host public

key of Switch A. For the specific configuration, refer to .

1.1.6 SSH Server Configuration

Example

2) Configure SwitchA

# Configure an IP address (10.165.87.137 in this case) for the VLAN interface on

SwitchA. This IP address and that of the VLAN interface on SwitchB must be in the

same network segment.

<H3C> system-view

[H3C] interface vlan-interface 1

[H3C-Vlan-interface1] ip address 10.165.87.137 255.255.255.0

[H3C-Vlan-interface1] quit

# Establish an SSH connection to server 10.165.87.136.

[H3C] ssh2 10.165.87.136

Username: client001

Trying 10.165.87.136 ...

Press CTRL+K to abort

Connected to 10.165.87.136 ...

The Server is not authenticated. Do you continue to access it?(Y/N):y

Do you want to save the server's public key?(Y/N):n

Enter password:

*************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

*************************************************************************

<H3C>

H3C S3600 Series User Manual

Other manuals for H3C S3600 Series