Preface
ARM DDI 0301H Copyright © 2004-2009 ARM Limited. All rights reserved. xxv
ID012310 Non-Confidential, Unrestricted Access
Signals
The signal conventions are:
Signal level The level of an asserted signal depends on whether the signal is
active-HIGH or active-LOW. Asserted means:
• HIGH for active-HIGH signals
• LOW for active-LOW signals.
Lower-case n At the start or end of a signal name denotes an active-LOW signal.
Additional reading
This section lists publications by ARM and by third parties.
See Infocenter,
http://infocenter.arm.com
, for access to ARM documentation.
ARM publications
This book contains information that is specific to this product. See the following documents for
other relevant information:
• ARM Architecture Reference Manual (ARM DDI 0406)
Note
The ARM DDI 0406 edition of the ARM Architecture Reference Manual (the ARM ARM)
incorporates the supplements to the previous ARM ARM, including the Security
Extensions supplement.
• Jazelle
®
V1 Architecture Reference Manual (ARM DDI 0225)
• AMBA
®
AXI Protocol V1.0 Specification (ARM IHI 0022)
• Embedded Trace Macrocell Architecture Specification (ARM IHI 0014)
• ARM1136J-S Technical Reference Manual (ARM DDI 0211)
• ARM11 Memory Built-In Self Test Controller Technical Reference Manual
(ARM DDI 0289)
• ARM1176JZF-S
™
and ARM1176JZ-S
™
Implementation Guide (ARM DII 0081)
• CoreSight ETM11
™
Technical Reference Manual (ARM DDI 0318)
• RealView
™
Compilation Tools Developer Guide (ARM DUI 0203)
• ARM PrimeCell
®
Vectored Interrupt Controller (PL192) Technical Reference Manual
(ARM DDI 0273).
• Intelligent Energy Controller Technical Overview (ARM DTO 0005).
Other publications
This section lists relevant documents published by third parties:
• IEEE Standard Test Access Port and Boundary-Scan Architecture specification, IEEE Std.
1149.1-1990 (JTAG).
• IEEE Standard for Binary Floating-Point Arithmetic, ANSI/IEEE Std 754-1985.
Figure 14-1 on page 14-2 is printed with permission IEEE Std. 1149.1-1990, IEEE Standard
Test Access Port and Boundary-Scan Architecture Copyright 2001, by IEEE. The IEEE
disclaims any responsibility or liability resulting from the placement and use in the described
manner.
To Next Page
Loading...
Need help?
General
