H3C S3600 Series

Operation Manual – MSTP
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 1
MSTP Configuration
1-46
# Configure the MST region.
[H3C-mst-region] region-name example
[H3C-mst-region] instance 1 vlan 10
[H3C-mst-region] instance 3 vlan 30
[H3C-mst-region] instance 4 vlan 40
[H3C-mst-region] revision-level 0
# Activate the settings of the MST region manually.
[H3C-mst-region] active region-configuration
# Specify Switch A as the root bridge of spanning tree instance 1.
[H3C] stp instance 1 root primary
2) Configure Switch B
# Enter MST region view.
<H3C> system-view
[H3C] stp region-configuration
# Configure the MST region.
[H3C-mst-region] region-name example
[H3C-mst-region] instance 1 vlan 10
[H3C-mst-region] instance 3 vlan 30
[H3C-mst-region] instance 4 vlan 40
[H3C-mst-region] revision-level 0
# Activate the settings of the MST region manually.
[H3C-mst-region] active region-configuration
# Specify Switch B as the root bridge of spanning tree instance 3.
[H3C] stp instance 3 root primary
3) Configure Switch C.
# Enter MST region view.
<H3C> system-view
[H3C] stp region-configuration
# Configure the MST region.
[H3C-mst-region] region-name example
[H3C-mst-region] instance 1 vlan 10
[H3C-mst-region] instance 3 vlan 30
[H3C-mst-region] instance 4 vlan 40
[H3C-mst-region] revision-level 0
# Activate the settings of the MST region manually.
[H3C-mst-region] active region-configuration
# Specify Switch C as the root bridge of spanning tree instance 4.