H3C S3600 Series User Manual

Operation Manual – Routing Protocol
H3C S3600 Series Ethernet Switches-Release 1510 Chapter 4
OSPF Configuration
4-11
AS. A common practice is to set the router ID to the IP address of an interface on the
router.
z Enabling OSPF
Comware supports multiple OSPF processes. To enable multiple OSPF processes on
a router, you need to specify different process IDs. OSPF process ID is only locally
significant; it does not affect the packet exchange between an OSPF process and
other routers. Therefore, packets can be exchanged between routers with different
OSPF processes IDs.
z Configuring an area and the network segments in the area. You need to plan
areas in an AS before performing the corresponding configurations on each
router.
When configuring the routers in the same area, please note that most configurations
should be uniformly made based on the area. Wrong configuration may disable
information transmission between neighboring routers and even lead to congestion or
self-loop of routing information.
Table 4-2 Basic OSPF configuration
Operation Command Description
Enter system view
system-view
—
Configure the router ID
router id router-id
Optional
If multiple OSPF processes run
on a router, you are
recommended to use the
router-id keyword in the ospf
command to specify different
router IDs for different
processes.
Enable OSPF and enter
OSPF view
ospf [ process-id
[ router-id
router-id ] ]
Required
Enter OSPF view.
Enter OSPF area view
area area-id
Required
Configure the network
segments in the area
network address
wildcard-mask
Required
By default, an interface does not
belong to any area.

H3C S3600 Series Specifications

General

Brand	H3C
Model	S3600 Series
Category	Switch
Language	English