Operation Manual – System Maintenance and Debugging
H3C S3600 Series Ethernet Switches-Release 1510
Chapter 1 BootROM and Host Software
Loading
1-13
<H3C> ftp 10.1.1.1
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):abc
331 Give me your password, please
Password:
230 Logged in successfully
[ftp] get S3600.btm
[ftp] bye
Note:
When using different FTP server software on PC, different information will be output to
the switch.
Step 2: Update the BootROM program on the switch.
<H3C> boot bootrom S3600.btm
This will update BootRom file on unit 1. Continue? [Y/N] y
Upgrading BOOTROM, please wait...
Upgrade BOOTROM succeeded!
Step 3: Restart the switch.
<H3C> reboot
Note:
Before restarting the switch, make sure you have saved all other configurations that
you want, so as to avoid losing configuration information.
2) Loading host software
Loading the host software is the same as loading the BootROM program, except that
the file to be downloaded is the host software file, and that you need to use the boot
boot-loader command to select the host software used for next startup of the switch.
After the above operations, the BootROM and host software loading is completed.
Pay attention to the following:
z The loading of BootROM and host software takes effect only after you restart the
switch with the reboot command.
To Next Page
Loading...
Need help?
General