Cisco 300 Series

User Interface Commands
OL-32830-01 Command Line Interface Reference Guide 1038
55
Syntax
enable [
privilege-level ]
Parameters
privilege-level—(Optional) Specifies the privilege level at which to enter the
system.(Range: 1,7,15)
Default Configuration
The default privilege level is 15.
Command Mode
User EXEC mode
Example
The following example enters privilege level 7.
switchxxxxxx# enable 7
enter password:**********
switchxxxxxx# Accepted
The following example enters privilege level 15.
switchxxxxxx# enable
enter password:**********
switchxxxxxx# Accepted
55.7 end
To end the current configuration session and return to the Privileged EXEC mode,
use the end command.
Syntax
end