EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #613 background imageLoading...
Page #613 background image
IPv6 Commands
613 OL-32830-01 Command Line Interface Reference Guide
27
Parameters
N/A
Default Configuration
IPv6 addressing is enabled.
Command Mode
Interface Configuration mode
User Guidelines
This command automatically configures an IPv6 link-local Unicast address on the
interface while also enabling the interface for IPv6 processing. The no ipv6 enable
command does not disable IPv6 processing on an interface that is configured with
an explicit IPv6 address.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
switchxxxxxx(config)#
interface vlan
1
switchxxxxxx(config-if)#
ipv6 enable
switchxxxxxx(config-if)#
exit
27.8 ipv6 icmp error-interval
Use the ipv6 icmp error-interval command in Global Configuration mode to
configure the interval and bucket size for IPv6 ICMP error messages. To return the
interval to its default setting, use the no form of this command.
Syntax
ipv6 icmp error-interval
milliseconds
[
bucketsize
]
no ipv6 icmp error-interval

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals