Cisco 300 Series

2
OL-32830-01 Command Line Interface Reference Guide 45
802.1X Commands
Dependencies Between Multi-Session Mode and System
Mode
Multi-session mode works differently in switch mode and router mode, as
described below:
• Multi-Session mode (called Full Multi-Session mode) supports Guest VLAN,
RADIUS VLAN attributes, and WEB-Based authentication are supported in
Sx300 in switch mode.
• Multi-Session mode (called Lite Multi-Session mode) does not support
Guest VLAN, RADIUS VLAN attributes, and WEB-Based authentication in
Sx300 in router mode.
List of Commands
2.1 aaa authentication dot1x
Use the aaa authentication dot1x Global Configuration mode command to specify
which servers are used for authentication when 802.1X authentication is enabled.
Use the no form of this command to restore the default configuration.
Syntax
aaa authentication dot1x default {radius | none | {radius | none}}
no aaa authentication dot1x default
Parameters
• radius - Uses the list of all RADIUS servers for authentication
• none - Uses no authentication
Default Configuration
RADIUS server.