Cisco 300 Series User Manual

IPv6 First Hop Security
555 OL-32830-01 Command Line Interface Reference Guide
25
The policy cannot be attached by the ipv6 source guard attach-policy (port mode)
command. The port_default policy is attached by default to a port, if no other
policy is attached to the port.
If an attached policy is removed, it is detached automatically before removing.
Examples
Example 1—The following example defines the IPv6 Source Guard policy named
policy1, places the router in IPv6 Source Guard Policy Configuration mode, and
configures the port as trusted:
switchxxxxxx(config)# ipv6 source guard policy policy1
switchxxxxxx(config-ipv6-srcguard)# trusted-port
switchxxxxxx(config)# exit
Example 2—The following example removes the attached IPv6 Source Guard
policy:
switchxxxxxx(config)# no ipv6 source guard policy policy1
Policy policy1 is applied on the following ports:
gi11, gi12
The policy1 will be detached and removed, are you sure [Y/N]Y
25.52 logging binding
To enable the logging of Binding table main events within an IPv6 Neighbor
Binding policy, use the logging binding command in Neighbor Binding Policy
Configuration mode. To return to the default, use the no form of this command.
Syntax
logging binding [enable | disable]
no logging binding

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48