CDP Commands
211 OL-32830-01 Command Line Interface Reference Guide
8
8.13 cdp holdtime
The cdp holdtime Global Configuration mode command specifies a value of the
Time-to-Live field into sent CDP messages. The no format of this command returns
to default.
Syntax
cdp holdtime
seconds
no cdp holdtime
Parameters
•
seconds
—Value of the Time-to-Live field in seconds. The value should be
greater than the value of the Transmission Timer. The value range is 10 -
255.
Default Configuration
180 seconds.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#
cdp holdtime
100
8.14 clear cdp counters
The clear cdp counters Global Configuration mode command resets the CDP
traffic counters to 0.
Syntax
clear cdp counters [global |
interface-id
]
Parameters
• global—Clear only the global counters.
To Next Page
Loading...
