EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #434 background imageLoading...
Page #434 background image
IGMP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide 434
21
no ip igmp snooping vlan
vlan-id
Parameters
•
vlan-id
—Specifies the VLAN.
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
IGMP snooping can be enabled only on static VLANs.
IGMPv1, IGMPv2, and IGMPv3 Snooping are supported.
To activate IGMP snooping, bridge multicast filtering must be enabled by the
bridge multicast filtering command.
The user guidelines of the bridge multicast mode command describes the
configuration that is written into the FDB as a function of the FDB mode and the
IGMP version that is used in the network.
Example
switchxxxxxx(config)#
ip igmp snooping vlan
2
21.3 ip igmp snooping vlan mrouter
To enable automatic learning of Multicast router ports on a VLAN, use the ip igmp
snooping vlan mrouter command in Global Configuration mode. To remove the
configuration, use the no form of this command.
Syntax
ip igmp snooping vlan
vlan-id
mrouter learn
pim-dvmrp
no ip igmp snooping vlan
vlan-id
mrouter learn
pim-dvmrp
Parameters
•
vlan-id
—Specifies the VLAN.

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals