Cisco 300 Series User Manual

MLD Snooping Commands
OL-32830-01 Command Line Interface Reference Guide 710
34
Default Configuration
MLDv1.
Command Mode
Global Configuration mode
Example
he following example sets the version of the MLD Snooping Querier VLAN 1 to 2:
switchxxxxxx(config)# ipv6 mld snooping vlan 1 querier version 2
34.7 ipv6 mld snooping vlan mrouter
To enable automatic learning of Multicast router ports, use the ipv6 mld snooping
vlan mrouter command in Global Configuration mode. To remove the configuration,
use the no form of this command.
Syntax
ipv6 mld snooping vlan
vlan-id mrouter learn pim-dvmrp
no ipv6 mld snooping vlan
vlan-id mrouter learn pim-dvmrp
Parameters
• vlan-id —Specifies the VLAN.
• pim-dvmrp—Learn Multicast router port by PIM, DVMRP and MLD
messages.
Default Configuration
Learning pim-dvmrp is enabled.
Command Mode
Global Configuration mode
User Guidelines
Multicast router ports can be configured statically with the bridge multicast
forward-all command.
You can execute the command before the VLAN is created.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48