Cisco 300 Series User Manual

802.1X Commands
57 OL-32830-01 Command Line Interface Reference Guide
2
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# dot1x host-mode multi-host
2.11 dot1x max-hosts
Use the dot1x max-hosts interface configuration command to configure the
maximum number of authorized hosts allowed on the interface. Use the no format
of the command to return to the default.
Syntax
dot1x max-hosts
count
no dot1x max-hosts
Parameters
• count —Specifies the maximum number of authorized hosts allowed on the
interface. May be any 32 bits positive number.
Default Configuration
No limitation.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
By default, the number of authorized hosts allowed on an interface is not limited.
To limit the number of authorized hosts allowed on an interface, use the dot1x
max-hosts command.
This command is relevant only for multi-session mode.
Example
The following example limits the maximum number of authorized hosts on Ethernet
port gi11 to 6:
switchxxxxxx(config)# interface gi1 1

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48