EasyManuals Logo

Cisco 300 Series User Manual

Cisco 300 Series
1117 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #661 background imageLoading...
Page #661 background image
Link Layer Discovery Protocol (LLDP) Commands
661 OL-32830-01 Command Line Interface Reference Guide
30
Syntax
lldp receive
no lldp receive
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
LLDP manages LAG ports individually. LLDP data received through LAG ports is
stored individually per port.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are received on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)#
interface
gi11
switchxxxxxx(config-if)#
lldp receive
30.19 lldp reinit
To specify the minimum time an LLDP port waits before reinitializing LLDP
transmission, use the lldp reinit Global Configuration mode command. To revert to
the default setting, use the no form of this command.
Syntax
lldp reinit
seconds
no lldp reinit

Table of Contents

Other manuals for Cisco 300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 300 Series and is the answer not in the manual?

Cisco 300 Series Specifications

General IconGeneral
ModelCisco 300 Series
CategorySwitch
DimensionsVaries by model
WeightVaries by model
Power over Ethernet (PoE)Available on select models
ManagementWeb-based GUI, SNMP, CLI
VLANsUp to 256
Security FeaturesACLs, 802.1X, Port Security
Humidity10% to 90% non-condensing
Ports8, 16, 24, 48

Related product manuals