Cisco 300 Series

Smartport Commands
837 OL-32830-01 Command Line Interface Reference Guide
44
Syntax
macro auto smartport
no macro auto smartport
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
This command is effective only when Auto Smartport is globally enabled.
Example
Enables the Auto Smartport feature on port 1:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# macro auto smartport
44.3 macro auto trunk refresh
The macro auto trunk refresh Global Configuration command reapplies the
Smartport macro on a specific interface, or to all the interfaces with the specified
Smartport type.
Syntax
macro auto trunk refresh [
smartport-type ] [ interface-id ]
Parameters
• smartport-type —Smartport type (switch, router, wireless access point (ap))
• interface-id —Interface Identifier (port or port channel).