Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide 660
30
Command Mode
Interface (Ethernet) Configuration mode
Example
switchxxxxxx(config)# lldp optional-tlv 802.1 protocol add stp
30.17 lldp run
To enable LLDP, use the lldp run Global Configuration mode command. To disable
LLDP, use the no form of this command.
Syntax
lldp run
no lldp run
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lldp run
30.18 lldp receive
To enable receiving LLDP on an interface, use the lldp receive Interface (Ethernet)
Configuration mode command. To stop receiving LLDP on an Interface (Ethernet)
Configuration mode interface, use the no form of this command.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48