Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 532
25
25.36 ipv6 nd raguard policy
To define an RA Guard policy name and place the switch in IPv6 RA Guard Policy
Configuration mode, use the ipv6 nd raguard policy command in Global
Configuration mode. To remove the RA Guard policy, use the no form of this
command.
Syntax
ipv6 nd raguard policy
policy-name
no ipv6 nd raguard policy policy-name
Parameters
• policy-name —The RA Guard policy name (up to 32 characters).
Default Configuration
No RA Guard policy is configured
Command Mode
Global Configuration mode
User Guidelines
This command defines the RA Guard policy name, and places the switch in IPv6
RA Guard Policy Configuration mode.
Each policy of the same type (for example, RA Guard policies) must have a unique
name. Policies of different types can have a same policy name.
The switch supports two predefined RA Guard policies, named: "vlan_default" and
"port_default":
ipv6 nd raguard policy vlan_default
exit
ipv6 nd raguard policy port_default
exit
The policies cannot be removed, but they can be changed. The no ipv6 nd raguard
policy does not remove these policies, it only removes the policy configuration
defined by the user.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48