Cisco 300 Series

CDP Commands
OL-32830-01 Command Line Interface Reference Guide 204
8
8.4 cdp advertise-v2
The cdp advertise-v2 Global Configuration mode command specifies version 2 of
transmitted CDP packets. The no format of this command specifies version 1.
Syntax
cdp advertise-v2
no cdp advertise-v2
Parameters
N/A
Default Configuration
Version 2.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# cdp run
switchxxxxxx(config)# cdp advertise-v2
8.5 cdp appliance-tlv enable
The cdp appliance-tlv enable Global Configuration mode command enables
sending of the Appliance TLV. The no format of this command disables the sending
of the Appliance TLV.
Syntax
cdp appliance-tlv enable
no cdp appliance-tlv enable
Parameters
N/A