Cisco 300 Series User Manual

DHCP Server Commands
285 OL-32830-01 Command Line Interface Reference Guide
12
in DHCP Pool Host Configuration mode. To remove the DNS server list, use the no
form of this command.
Syntax
dns-server
ip-address [ ip-address2 ... ip-address8 ]
no dns-server
Parameters
• ip-address [ ip-address2 ... ip-address8 ]—Specifies the IP addresses of
DNS servers. Up to eight addresses can be specified in one command line.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
No DNS server is defined.
User Guidelines
If DNS IP servers are not configured for a DHCP client, the client cannot correlate
host names to IP addresses.
Example
The following example specifies 10.12.1.99 as the client domain name server IP
address.
switchxxxxxx(config-dhcp)# dns-server 10.12.1.99
12.8 domain-name
To specify the domain name for a DHCP client, use the domain-name command in
DHCP Pool Network Configuration mode or in DHCP Pool Host Configuration
mode. To remove the domain name, use the no form of this command.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48