Cisco 300 Series User Manual

17
OL-32830-01 Command Line Interface Reference Guide 380
EEE Commands
1
17.1 eee enable (global)
To enable the EEE mode globally, use the eee enable Global Configuration
command. To disable the mode, use the no format of the command.
Syntax
eee enable
no eee enable
Parameters
This command has no arguments or keywords.
Default Configuration
EEE is enabled.
Command Mode
Global Configuration mode
User Guidelines
In order for EEE to work, the device at the other end of the link must also support
EEE and have it enabled. In addition, for EEE to work properly, auto-negotaition
must be enabled; however, if the port speed is negotiated as 1Giga, EEE always
works regardless of whether the auto-negotiation status is enabled or disabled.
If auto-negotiation is not enabled on the port and its speed is less than 1 Giga, the
EEE operational status is disabled.
Example
switchxxxxxx(config)# eee enable

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48