Cisco 300 Series

DHCP Server Commands
OL-32830-01 Command Line Interface Reference Guide 282
12
Parameters
• filename —Specifies the file name used as a boot image. (Length: 1–128
characters).
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Example
The following example specifies boot_image_file as the default boot image file
name for a DHCP client.
switchxxxxxx(config-dhcp)# bootfile boot_image_file
12.4 clear ip dhcp binding
To delete the dynamic address binding from the DHCP server database, use the
clear ip dhcp binding command in Privileged EXEC mode.
Syntax
clear ip dhcp binding {
address | *}
Parameters
• address —Specifies the binding address to delete from the DHCP
database.
• * —Clears all dynamic bindings.
Command Mode
Privileged EXEC mode
User Guidelines
Typically, the address supplied denotes the client IP address. If the asterisk (*)
character is specified as the address parameter, DHCP clears all dynamic
bindings.