Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide 764
39
Example
The following example configures the number of expedite queues as 2.
switchxxxxxx(config)#
priority-queue out num-of-queues
2
39.20 traffic-shape
Use the traffic-shape Interface (Ethernet) Configuration mode command to
configure the egress port shaper. Use the no form of this command to disable the
shaper.
Syntax
traffic-shape
committed-rate
[
committed-burst
]
no traffic-shape
Parameters
• committed-rate—Specifies the maximum average traffic rate (CIR) in kbits
per second (kbps). (Range: GE: 64kbps–maximum port speed
• committed-burst—Specifies the maximum permitted excess burst size
(CBS) in bytes. (Range: 4096 - 16762902 bytes)
Default Configuration
The shaper is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The egress port shaper controls the traffic transmit rate (Tx rate) on a port.
Example
The following example sets a traffic shaper on gi11 when the average traffic rate
exceeds 64 kbps or the normal burst size exceeds 4096 bytes.
switchxxxxxx(config)#
interface gi1
1
To Next Page
Loading...
