Cisco 300 Series

Quality of Service (QoS) Commands
781 OL-32830-01 Command Line Interface Reference Guide
39
• out-dscp—Specifies up to 8 DSCP mapped values, separated by spaces.
(Range: 0–63)
Default Configuration
The default map is the Null map, which means that each incoming DSCP value is
mapped to the same DSCP value.
Command Mode
Global Configuration mode
User Guidelines
This is the only map that is not globally configured. It is possible to have several
maps and assign each one to a different port.
Example
The following example changes DSCP values 1, 2, 4, 5 and 6 to DSCP Mutation
Map value 63
.
switchxxxxxx(config)# qos map dscp-mutation 1 2 4 5 6 to 63
39.34 show qos map
Use the show qos map Privileged EXEC mode command to display the various
types of QoS mapping.
Syntax
show qos map [dscp-queue | dscp-dp | policed-dscp | dscp-mutation]
Parameters
• dscp-queue—Displays the DSCP to queue map.
• dscp-dp—Displays the DSCP to Drop Precedence map.
• policed-dscp—Displays the DSCP to DSCP remark table.
• dscp-mutation—Displays the DSCP-DSCP mutation table.