Cisco 300 Series

802.1X Commands
OL-32830-01 Command Line Interface Reference Guide 64
2
Examples
Example 1. This example enables user-based VLAN assignment. If the RADIUS
server authorized the supplicant, but did not provide a supplicant VLAN, the
supplicant is rejected.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# dot1x radius-attributes vlan
switchxxxxxx(config-if)# exit
Example 2. This example enables user-based VLAN assignment. If the RADIUS
server authorized the supplicant but did not provide a supplicant VLAN, the
supplicant is accepted and the static VLAN configurations is used.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# dot1x radius-attributes static
switchxxxxxx(config-if)# exit
2.17 dot1x re-authenticate
The dot1x re-authenticate Privileged EXEC mode command manually initiates
re-authentication of all 802.1X-enabled ports or the specified 802.1X-enabled
port.
Syntax
dot1x re-authenticate [
interface-id ]
Parameters
• interface-id —Specifies an Ethernet port.
Default Configuration
If no port is specified, command is applied to all ports.
Command Mode
Privileged EXEC mode