Cisco 300 Series

Authentication, Authorization and Accounting (AAA) Commands
91 OL-32830-01 Command Line Interface Reference Guide
3
Parameters
• default—Uses the default list created with the aaa authentication login
command.
• list-name —Uses the specified list created with the aaa authentication login
command.
Default Configuration
default
Command Mode
Line Configuration Mode
Examples
Example 1 - The following example specifies the login authentication method as
the default method for a console session.
switchxxxxxx(config)# line console
switchxxxxxx(config-line)# login authentication default
Example
Example 2 - The following example sets the authentication login methods for the
console as a list of methods.
switchxxxxxx(config)# aaa authentication login authen-list radius local none
switchxxxxxx(config)# line console
switchxxxxxx(config-line)# login authentication authen-list
3.4 enable authentication
The enable authentication Line Configuration mode command specifies the
authentication method for accessing a higher privilege level from a remote Telnet
or console. Use the no form of this command to restore the default authentication
method.
Syntax
enable authentication {default
| list-name}