Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 544
25
Example 4—In the following example, Neighbor Binding Integrity detaches policy
policy1 detached to the gi11 port:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# no ipv6 neighbor binding attach-policy policy1
switchxxxxxx(config-if)# exit
25.43 ipv6 neighbor binding attach-policy
(VLAN mode)
To attach a Neighbor Binding policy to a specific VLAN, use the ipv6 neighbor
binding attach-policy command in VLAN Configuration mode. To return to the
default, use the no form of this command.
Syntax
ipv6 neighbor binding attach-policy
policy-name
no ipv6 neighbor binding attach-policy
Parameters
• policy-name —The Neighbor Binding policy name (up to 32 characters).
Default Configuration
The Neighbor Binding default policy is applied.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use this command to attach a Neighbor Binding policy to a VLAN.
If a policy specified by the
policy-name argument is not defined, the command is
rejected.
Use the no form of the command to return to detach the current policy and
reattach the default policy. The no form of the command has no effect if the default
policy was attached.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48