Cisco 300 Series User Manual

IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide 620
27
Example 3. The following example deletes all static entries in the IPv6 neighbor
discovery cache on VLAN 1:
switchxxxxxx(config)# no ipv6 neighbor vlan1
Example 4. The following example deletes all static entries in the IPv6 neighbor
discovery cache on all interfaces:
switchxxxxxx(config)# no ipv6 neighbor
27.12 ipv6 unreachables
Use the ipv6 unreachables command in Interface Configuration mode to enable
the generation of Internet Control Message Protocol for IPv6 (ICMPv6)
unreachable messages for any packets arriving on a specified interface.
To prevent the generation of unreachable messages, use the no form of this
command.
Syntax
ipv6 unreachables
no ipv6 unreachables
Parameters
N/A.
Default Configuration
The sending of ICMP IPv6 unreachable messages is enabled.
Command Mode
Interface Configuration mode
User Guidelines
If the switch receives a Unicast packet destined for itself that uses a protocol it
does not recognize, it sends an ICMPv6 unreachable message to the source.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48