RADIUS Commands
791 OL-32830-01 Command Line Interface Reference Guide
40
Example
The following example defines the authentication key for all RADIUS
communications between the device and the RADIUS daemon.
switchxxxxxx(config)#
radius-server key
enterprise-server
40.3 radius-server retransmit
Use the radius-server retransmit Global Configuration mode command to specify
the number of times the software searches the list of RADIUS server hosts. Use
the no form of this command to restore the default configuration.
Syntax
radius-server retransmit
retries
no radius-server retransmit
Parameters
• retransmit
retries
—Specifies the number of retry retransmissions (Range:
1–15).
Default Configuration
The software searches the list of RADIUS server hosts 3 times.
Command Mode
Global Configuration mode
Example
The following example configures the number of times the software searches all
RADIUS server hosts as 5.
switchxxxxxx(config)#
radius-server retransmit
5
To Next Page
Loading...
