Cisco 300 Series User Manual

IGMP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide 444
21
21.13 ip igmp snooping vlan querier version
To configure the IGMP version of an IGMP Snooping querier on a specific VLAN,
use the ip igmp snooping vlan querier version command in Global Configuration
mode. To return to the default, use the no form of this command.
Syntax
ip igmp snooping vlan
vlan-id querier version {2 | 3}
no ip igmp snooping
vlan vlan-id querier version
Parameters
• vlan-id —Specifies the VLAN.
• querier version 2—Specifies that the IGMP version would be IGMPv2.
• querier version 3—Specifies that the IGMP version would be IGMPv3.
Default Configuration
IGMPv2.
Command Mode
Global Configuration mode
Example
The following example sets the version of the IGMP Snooping Querier VLAN 1 to 3:
switchxxxxxx(config)# ip igmp snooping vlan 1 querier version 3
21.14 ip igmp snooping vlan immediate-leave
To enable the IGMP Snooping Immediate-Leave processing on a VLAN, use the ip
igmp snooping vlan immediate-leave Global Configuration mode command in
Global Configuration mode. To return to the default, use the no form of this
command.
Syntax
ip igmp snooping vlan
vlan-id immediate-leave

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48