Cisco 300 Series

System Management Commands
OL-32830-01 Command Line Interface Reference Guide 976
50
50.6 service cpu-utilization
To enable measuring CPU utilization, use the service cpu-utilization Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
service cpu-utilization
no service cpu-utilization
Parameters
This command has no arguments or keywords.
Default Configuration
Measuring CPU utilization is enabled.
Command Mode
Global Configuration mode
User Guidelines
Use the service cpu utilization command to measure information on CPU
utilization.
Example
The following example enables measuring CPU utilization.
switchxxxxxx(config)# service cpu-utilization
50.7 set system
To place the device into various modes depending on the parameters entered, use
the set system Privileged EXEC mode command.
Syntax
set system