Cisco 300 Series User Manual

IPv6 First Hop Security
589 OL-32830-01 Command Line Interface Reference Guide
25
Example 3—The following example displays the user defined policies:
switchxxxxxx# show ipv6 neighbor binding policy
policy1
policy2
25.78 show ipv6 neighbor binding prefix table
To display contents of the Neighbor Prefix table, use the show ipv6 neighbor
binding prefix table command in Privilege EXEC configuration mode.
Syntax
show ipv6 neighbor binding prefix table [vlan
vlan-id ]
Parameters
• vlan vlan-id —Displays the prefixes that match the specified VLAN.
Command Mode
Privileged EXEC mode
User Guidelines
This command displays the Neighbor Prefix table. The display output can be
limited to the specified VLAN. If no VLAN is configured, all prefixes are displayed.
Example
The following example displays the learned prefixes:
switchxxxxxx# show ipv6 neighbor binding prefix table
Flags: A - the prefix can be used for autoconfig (stateless configuration)
Neighbor Prefix Table has 4 entries
VLAN Prefix Type Flags Remaining Lifetime
7 2004:1::/64 static A
7 2006:1::/64 dynamic 1230
7 2008:1::/64 static

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48