Cisco 300 Series User Manual

Power over Ethernet (PoE) Commands
OL-32830-01 Command Line Interface Reference Guide 726
36
36.3 power inline legacy support disable
To disable the legacy PDs support, use the power inline legacy support disable
Global Configuration mode command. To enable the legacy support, use the no
form of this command.
Syntax
power inline legacy support disable
no power inline legacy support disable
Parameters
N/A.
Default Configuration
Legacy support is enabled.
Command Mode
Global Configuration mode
Example
The following example disables legacy PDs support.
switchxxxxxx(config)# power legacy support disable
36.4 power inline powered-device
To add a description of the powered device type, use the power inline
powered-device Interface Configuration mode command. To remove the
description, use the no form of this command.
Syntax
power inline powered-device
pd-type
no power inline powered-device

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48