Cisco 300 Series User Manual

IPv6 First Hop Security
485 OL-32830-01 Command Line Interface Reference Guide
25
Default policies can never be deleted. You can only delete the user-added
configuration.
Lists of Commands
25.1 address-config
To specify allowed configuration methods of global IPv6 addresses within an IPv6
Neighbor Binding policy, use the address-config command in Neighbor Binding
Policy Configuration mode. To return to the default, use the no form of this
command.
Syntax
address-config [stateless | any] [dhcp]
no address-config
Parameters
• stateless—Only auto configuration for global IPv6 bound from NDP
messages is allowed.
• any—All configuration methods for global IPv6 bound from NDP messages
(stateless and manual) are allowed. If no keyword is defined the any
keyword is applied.
• dhcp—Bound from DHCPv6 is allowed.
Default Configuration
Policy attached to port or port channel: the value configured in the policy attached
to the VLAN.
Policy attached to VLAN: global configuration.
Command Mode
Neighbor Binding Policy Configuration mode.
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48