Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 574
25
25.67 show ipv6 first hop security active
policies
To display information about the policies applied to the port and to the VLAN, use
the show ipv6 first hop security active policies command in privileged EXEC
mode.
Syntax
show ipv6 first hop security active policies interface
interface-id vlan vlan-id
Parameters
• interface interface-id —Port Identifier (Ethernet port or port channel).
• vlan vlan-id —VLAN Identifier.
Command Mode
Privileged EXEC mode
User Guidelines
This command displays policies applied to frames arriving on given port and
belonging to the given VLAN. The policies are calculated automatically by using
the policies attached to the port, VLAN, and the global configuration
Example
The following example displays the active attached policies on
gi1 1 and VLAN
100:
switchxxxxxx# show ipv6 first hop security active policies interface gi11 vlan
100
IPv6 First Hop Security is enabled on VLANs:1-4,6,7,100-120
IPv6 DHCP Guard is enabled on VLANs:1-4
IPv6 ND Inspection is enabled on VLANs:1-4,6,7,100-120
IPv6 Neighbor Binding Integrity is enabled on VLANs:1-4,6,7,100-120
IPv6 RA Guard is enabled on VLANs:1-4,6,7,100-120
IPv6 Source Guard is enabled on VLANs:1-3,7,100-112
gi11, VLAN 100

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48