Cisco 300 Series User Manual

Network Management Protocol (SNMP) Commands
OL-32830-01 Command Line Interface Reference Guide 884
45
Command Mode
Global Configuration mode
Example
The following example sets the device location to New_York.
switchxxxxxx(config)# snmp-server location New_York
45.22 snmp-server set
To define SNMP MIB commands in the configuration file if a MIB performs an action
for which there is no corresponding CLI command, use the snmp-server set Global
Configuration mode command.
Syntax
snmp-server set
variable-name name value [ name2 value2 ...]
Parameters
• variable-name—Specifies an SNMP MIB variable name, which must be a
valid string.
• name value —Specifies a list of names and value pairs. Each name and
value must be a valid string. In the case of scalar MIBs, there is only a single
name-value pair. In the case of an entry in a table, there is at least one
name-value pair, followed by one or more fields.
Default Configuration
None
Command Mode
Global Configuration mode
User Guidelines
Although the CLI can set any required configuration, there might be a situation
where an SNMP user sets a MIB variable that does not have an equivalent CLI
command. To generate configuration files that support those situations, the system
uses snmp-server set. This command is not intended for the end user.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48