Cisco 300 Series

28
OL-32830-01 Command Line Interface Reference Guide 633
Link Aggregation Control Protocol (LACP)
Commands
1
28.1 lacp port-priority
To set the physical port priority, use the lacp port-priority Interface (Ethernet)
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
lacp port-priority
value
no lacp port-priority
Parameters
value—Specifies the port priority. (Range: 1use the no form of this
command65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example sets the priority of
gi1 6.
switchxxxxxx(config)# interface gi16
switchxxxxxx(config-if)# lacp port-priority 247