53
OL-32830-01 Command Line Interface Reference Guide 1016
IPv6 Tunnel Commands
53.0
53.1 interface tunnel
To enter into the Interface Configuration (Tunnel) mode, use the interface tunnel
command in Global Configuration mode.
Syntax
interface tunnel
number
Parameters
•
number
—Specifies the tunnel number.
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
The following example enters the Interface Configuration (Tunnel) mode.
switchxxxxxx(config)#
interface tunnel
1
switchxxxxxx(config-if)#
tunnel source
auto
switchxxxxxx(config-if)#
exit
To Next Page
Loading...
